The SST-SS-10 GSM router is a device that can be used on the Mircom to connect it to the cell phone network. It can also replace an existing Telkom copper line connected to a older analog PABX and connect to the cell phone GSM network. Analogue equipment will be able to make mobile calls from the modem through any SIM network of your choice.
Features
- Matches to complex line impedance
- Power saving feed-bridge
- Signal level indicator LEDs
- Busy indicator
- Network indicator
- SMA antenna connector
- Module On/Off switch allows Network Detach
- Power supply 300mA at 12 VDC
- RJ11 connector for telephone
- DB9 connector for programming
- 900/1800 MHz operation in 2G GSM mode
- 900/2100 MHz operation in 3G UMTS mode (additional 850MHz optional)
Specifications
- Software
- Comfort Tone
- CLI restriction
- Settable digit count
- Settable dial timeout
- Automatic call termination
- Transmit & receive levels adjustable
- Optional reversal
- Optional line current break
- Optional periodic module reboot
- Full rate, enhanced full rate & half rate operation
- Supports Adaptive Multi-rate (AMR)
- Preferred network selection (Network locking)
- 2G, 3G or automatic network selection
- Dial-In modem functionality (2G mode only)
- 4 minute timer to reset module if not registered on the network
- 128 Programmable Call Back numbers
- Settable SIM Pin Number
- Supports International SIM card operation
- Maintenance
- Routine periodic SMS reports
- Feed bridge voltages
- Number of forcedly cut calls
- Number of unanswered calls
- Number of answered calls
- Total duration of answered calls
- SMS report on zero traffic (no calls made for specified interval)
- Request reports
- Request setting information
- Change set-up information by SMS
- 2 authorized maintainers
- Programmable byserial port, telephone or SMS